get in touch
https://www.loom.com/share/b39b59c7ca70454db8ccecf5a9dcf792 The above video goes over the basic troubleshooting steps for a Secure Access Point (SAP). For written instructions, please see Secure Access Point (SAP) Troubleshooting
• AUTO FAN: Fan automatically operated by the HVAC system.• FAN ON: Manual Fan mode. Fan stays on until mode is changed back to Auto.Optional Fan ModeFan Cycler. If the Fan Cycler feature is enabled in the Installer Setup, the additional fanmode "Cycle" will be shown in the Fan Mode menu. This mode cycles the […]
If no lights are lit, check the power cable and the breaker for the outlet. The power light will be solid green. Either the 2G or 5G light should be lit. It will be flashing or solid green. Only one of those lights will be in use. Confirm that the Ethernet cord is properly connected. […]
WiTemp+ Battery Replacement Remove the lid from each sensor by pressing inward on the tab on the right side of the sensor (see pic with arrow) and lifting the lid, then install the batteries. IMPORTANT: Do this step one sensor at a time as mixing up the lids with the ID numbers will cause a […]
SiteSage Gateway Troubleshooting Steps The first challenge with troubleshooting a gateway is locating the device. Some locations have gateways connected by Ethernet near their IT equipment or in the office. Others have WiFi gateways that could be anywhere on site. Once located, please follow the steps below. Support is available to assist at any point […]
https://www.loom.com/share/e92f4b9d452d476a962747a43e12d2ce?sid=775a90a3-4f8e-43bc-affd-3e464df6ec73 The above video goes through the basic Gateway Troubleshooting Steps. For written instructions, please see Gateway Troubleshooting Guide
